V1-M DAW Controller – Basic Testing, Setup & Encoder Functions

Also applies to: V1X Series

This article outlines the built-in diagnostic and configuration modes available on the iCON V1-M DAW controller. These functions are accessed by pressing specific encoders during power-on and are useful for testing, calibration, and system setup.

Basic Testing & Configuration Modes

Fader Calibration

To enter fader calibration mode:
Press encoder 1, then power on the device.
Encoders 1–8 adjust the calibration values for faders 1–8.

For the Master Fader (channel 9):

• Press the REC button on track 8 to increase the value
• Press the SOLO button on track 8 to decrease the value

The default calibration value is 85.

• If the fader moves slowly or lacks force, increase the value to 88 or 90
• If the fader shakes, reduce the value to 83, 82, or 80
• Do not exceed a value of 92
  Press encoder 8 to save the settings.

LCD Backlight Adjustment

Press encoder 2, then power on the device.
This mode allows adjustment of LCD backlight brightness:

• LCD1 controls the top display
• LCD2 controls the lower display

Default value: 65
Minimum: 25
Maximum: 90
Press encoder 8 to save the settings.

LED and Display Test

Press encoder 3, then power on the device.
This mode tests button LEDs, meter LEDs, character displays, and numeric displays.

System Selection

Press encoder 4, then power on the device.
Use the encoders to select the desired system mode.
The device will automatically save and exit after selection.

LCD Test

Press encoder 5, then power on the device.
This mode runs a full LCD screen test.

Fader Aging Test

Press encoder 6, then power on the device.
This mode activates continuous fader movement to test motor durability.

Encoders 7 & 8

Currently not assigned to specific test functions.
Note: Encoder 8 may be used to save parameters in certain modes.

Factory Reset

To reset the device to factory settings:
Press and hold encoders 2 and 3, then power on the device.

Jog Wheel Functions

Jog Wheel Lock & Sensitivity

The jog wheel can be locked and its sensitivity adjusted.
Refer to the Jog Wheel Lock and Resolution Update Guide for full instructions.

Navi and Focus Buttons

Located around the jog wheel:

• Navi (top left corner): Functions like arrow keys on a keyboard
• Focus (top right corner): Used to toggle jog wheel lock and activate focus mode