Basic settings and various self-tests can be accessed via your V1-M/X controller.

They are as follows;

1. Fader Calibration
2. LCD Backlight
3. LED and LCD Character Test
4. System Select
5. LCD Test
6. Aging Test
7. Factory Reset

        1. Fader Calibration

Press and hold encoder 1 while powering on the controller, the device will then enter Fader Calibration mode.

The encoder rotation of channels 1 to 8 will adjust the fader parameters of channels 1 to 8. 

The 9th fader (Master Fader), can be adjusted by pressing the REC button on the 8th channel to increase the value, and pressing the SOLO button on the 8th channel to decrease the value.

The default value for numerical calibration is "85". If the fader moves slowly or there is insufficient force, please try increasing this value. You can try 88 or 90. However,  it is best not to exceed the value of '92'. If there is a shaking phenomenon on the fader , it is necessary to reduce this value. You can try 83, 82, or 80. 

Press encoder 8 to save the fader values and exit.

2. LCD Backlight

Press and hold encoder 2 while powering on the controller, the device will enter the LCD backlight adjustment screen.

LCD1 represents the overall adjustment of the top LCD backlight parameters, with a default value of "65", a minimum limit of "25", and a maximum limit of "90". 

LCD2 represents the overall adjustment of lower LCD backlight parameters. The default value of the parameter is "65", with a minimum limit of "25" and a maximum limit of "90". 

Press encoder 8 to save the LCD Backlight values and exit.

3. LED Test

Press and hold encoder 3 while powering on the controller. 

The device will enter the LED test.

All the LED’s should light up including, the button LED’s, meter LED’s, characters display, and digital display of numbers.

To exit the LED test, simply power cycle the controller.

4. System Select

Press and hold encoder 4 while powering on the controller. The device will enter the system selection.

Press the corresponding encoder to select your system, Win or Mac.

When the selection is completed, the system select menu will automatically exit and save the setting.

The controller will then start up as normal. You only need to do this once, until such time as you change your OS. 

5. LCD Test

Press and hold encoder 5 while powering on the controller, the device will then enter the LCD Test mode.

All The LCD’s will cycle through the 8 colors available on the LCD displays. To exit the LCD test, simply power cycle the controller

6. AGING Test

Press and hold encoder 6 while powering on the controller, the device will enter the Aging fader test. 

You should see all faders moving up and down the full length of the fader tracks.

To exit the Aging test, simply power cycle the controller

7. Factory Default

To perform a factory reset on your controller, press and hold encoders 2 and 3 at the same time while powering on the device. The controller will perform a factory reset and continue on to start up as normal.